The D-Link ANT24-CB03N, ANT24-CB06N & ANT24-CB09N Antenna RF Cables are designed for outdoor or rooftop installations when distance between a wireless Access Point (AP) & an antenna is required. With these Radio Frequency (RF) cables & D-Link’s ANT24 line of outdoor antennas, an indoor wireless AP/Bridge can be used in an outdoor deployment*. The D-Link ANT24 Antenna RF Cables are available in three lengths: 3m (9.84ft); 6m (19.68ft); & 9m (29.52ft). All of them can be inter-connected. On one end of each cable is an “N-plug” & on the other end is an “N-jack” with high-quality N-type connectors. These RF Cables are based on the HDF-400 specification to minimize the signal loss introduced to a wireless LAN. The frequency responses of the cables coincide with the 2.4GHz ISM band so that the cables are ideal for both IEEE 802.11b & IEEE 802.11g WLANs. With 50 ohms of impedance, the RF cables can be used with most D-Link WLAN products. This impedance match eliminates any Voltage Standing Wave (VSW) issues in an RF circuit & any noticeable decrease in the amplitude of the RF signal. D-Link includes a RF pigtail adapter in N-type & SMA connectors with each of its ANT24 antennas. The D-Link Antenna Cables can be easily installed with surge protectors & D-Link Wireless APs. Using these reliable pre-cut RF cables with their pre-installed connectors ensures that the WLAN equipment operates optimally, providing the best performance possible.